In this report we’re going to look at how to make your own dog mask. We’ll cover the basics and then go on to look at some of the more advanced tips and tricks which you can use.

If you have a dog that likes to bark, and particularly if your dog loves to play in the garden and other regions of the house, you will need to get them some particular dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the setup which will look a little scary at first, but it’s actually quite simple. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape from the cardboard, so you will have to cut around the edge of the mask so you get something which looks like a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.

Then you’ll need to wrap the cardboard around the edges of the paper plate, making sure there is a good seal between the two pieces so that you can ensure that nothing will leak when you place the mask on. Make sure that the edges are cut so the edges are not sharp, as this can damage the edges of the mask.

Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the entire mask. You will want to start with one side of the mask , so that you can work your way round it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it is best that you leave about one-third of an inch of paint on the edges so that it runs across the cardboard.

Don’t worry too much about the paint getting stuck to your mask. It’s easy to eliminate it later, and it will leave you with a nice finished mask to show off to everybody! It’s also a good idea to wash away any excess paint after you’re done, so that you don’t wind up with smudges or smears on your dog.

Then it is time to paste the mask onto your dog’s head. First you will need to be certain that you get a secure fit between the mask and your dog’s head. Once you’ve made sure that it is secure, then you may start to glue the mask onto the dog’s face. Take the piece of cardboard that’s used oxygen mask for dog for the base of the mask and fold it over. Be certain it’s quite powerful and then use your hands to secure the cardboard down in place.

Keep your hands out of the way and use tape to hold it in place as you repeat the process on the cardboard folds until you have the mask snugged firmly onto the surface of your dog. Don’t make the folds too big or else it might look messy. Once you’ve done this, you can then take out the mask and attach the cardboard ears. And attach the other part of the mask onto the dog. Make certain that the ears are flat and be sure that it’s not too short or long as this will cause some problems with the mask slipping off the dog’s face.

If you are using a dog mask as your dog protection, you will need to do some sanding to make sure that it is secure on your dog. You can accomplish it by sanding off any excess paper which might have been eliminated from your mask.